Multiquip GB3LED Manuel D’Utilisation

1.  Connect the AC power cable to the 120 VAC receptacle 

on the generator used. See Figure 13.

2.  Start the generator as indicated in the generator 

manual.

3.  Turn on the power of the generator. The balloon will 

start to inflate and the lamp will turn on. at 200 W.

1.  Press the dimmer switch to control the brightness of 

the lamp (Figure 14). The lamp can be turned off or 

set to 100W, 200W, 300W. The corresponding LED will 

light red when selected (Figure 15).

20A

120 VAC

RECEPTACLE

POWER

CABLE

TYPICAL

GENERATOR

FRONT PANEL

DIMMER

SWITCH

2.  Zip up the bottom of the balloon completely after use 

of the dimmer switch.

Noise coming from the unit during operation can be 

eliminated.
1.  Press and hold the dimmer switch (Figure 14) for 2 

seconds. The blue LED in the center of the switch will 

flash when in silent mode.

2.  To switch back to normal mode, press and hold the 

dimmer switch for 3 seconds. The blue LED will stop 

flashing.

1.  Turn off the power switch of the generator. The balloon 

should start to deflate and the lamp will turn off.

2.  Disconnect the AC power cable from the generator.

The brightness of the lamp can still be adjusted when 

in silent mode.
When unit is restarted, it will revert to normal mode 

even if silent mode was selected prior to shutdown.