Troy-Bilt LS 33 TB Manuel D’Utilisation

If the log splitter will not be used for more than 30 days, prepare 

for storage as follows:

Never store machine with fuel in the 

fuel tank inside of building where fumes may reach 

an open flame or spark, or where ignition sources 

are present such as hot water and space heaters, 

furnaces, clothes dryers, stoves, electric motors, etc.

Clean the log splitter thoroughly.

1. 

NOTE: The use of a pressure washers or garden hose to 

clean your log splitter is not recommended. They may 

cause damage to bearings or the engine. The use of water 

will result in shortened life and reduce serviceability.
Wipe the log splitter with an oiled rag to prevent rust, 

2. 

especially on the wedge and the beam.
Drain the fuel tank. Always drain the fuel into an approved 

3. 

container outdoors, away from an open flame. Be sure that 

the engine is cool before draining the fuel. Do not smoke 

while handling fuel.
Start the engine and let it run until the fuel lines and 

4. 

carburetor are empty.
Remove the spark plug. Holding a rag over the cylinder 

5. 

hole, pour approximately 1⁄2-ounce (approximately one 

tablespoon) of engine oil into the cylinder and crank slowly 

to distribute the oil.
Replace the spark plug.

6. 

Do not store the gasoline from one season to another.

7. 

Replace your gasoline can if it starts to rust. Rust and/or dirt 

8. 

in the gasoline will cause problems.
Store the log splitter in a clean, dry area. Do not store next 

9. 

to any corrosive materials, such as fertilizer.
NOTE: If storing in an unventilated or metal storage shed, 

be certain to rustproof the equipment by coating with a 

light oil or silicone.