Snapper GP216512RV Manuel D’Utilisation

 

 

5.  Hold the slotted end of the drive disc bolt with a 
screwdriver and remove the nut and internal tooth lock 
washer.  See Figure 4.16. 
 
 

 

 

6.  Lift the drive disc off the idler arm and remove worn 
belt. 
7.  Loop one end of new belt over engine pulley and 
insert the other end through slot in deck. See Figure 
4.16. 
8.  Loop the belt around the pulley on the bottom of the 
drive disc. 
9.  Reinstall drive disc and retaining hardware. 
10.  Align bushing in bracket and drive disc. 
11. Reinstall blade hub and cutter blade. Recom-
mended torque for blade cap screw is 30 to 40 ft. lbs. 
13.  Use a stiff wire, such as a coat hanger, with a hook 
fashioned on one end to pull the hooked end of the 
idler spring through the large hole in the right wheel 
bracket. See Figure 4.17. 
14.  Reinstall the driven disc assembly. 

 
 
 
 

 

 

4.4.2.  Transmission Poly-V Belt Replacement 
1. Remove the driven disc. Refer to Section 
Replacing Driven Disc Rubber Ring” for procedure. 
4.   Note the routing of the old belt around the 
three pulleys before removing it.  See Figure 4.18. 

 

 

 

5.   Place new Poly-V Belt over end of hex shaft 
and onto driven pulley. 
6.   Work belt onto top of idler pulley. 
7.   Twist belt sideways and pull it upward between 
the differential bracket and drive pulley and then 
down into the pulley groove. Make sure the Poly-V 
Belt is above belt guide. See Figure 4.18.