Snapper GP216512RV Manuel D’Utilisation

 

1.  Move ground speed control to the desired 
speed position. See Figure 2.4. 
2.  Move wheel drive control against handle to 
engage wheel drive and propel mower forward. 
Forward speed can be adjusted while the mower is 
moving by changing position of the ground speed 
control. See Figure 2.4. 

 

 

 

Stop engine and blade by releasing the blade 
control. Stop forward motion of mower by releasing 
the wheel drive control.  
 

The height of the mower handle can be adjusted 
as follows: 
1. Loosen the nuts on each lower handle as 
shown in Figure 2.5. 

 

 

2.  Move upper mower handle up or down until the 
desired position is achieved. 
3.  Tighten the lower nuts on each lower handle to 
maintain desired position. 
 

 
2.5  CUTTING HEIGHT ADJUSTMENT 

1.  Pull the height adjusting latch outward and 
move to desired cutting height. See Figure 2.6. 

 

 

2.  Set all wheels at the same cutting height.  The 
highest cutting position is Notch 6. The lowest 
cutting position is Notch 1. See Figure 2.7. 

 

 

 

HIGHER 

LOWER