Snapper 5900550 Manuel D’Utilisation

www.SnapperPro.com

 1.  Disengage the PTO, stop the engine, remove the ignition 

key, and engage the parking brake.

 2.  Locate the brake springs (A, Figure 23) underneath the 

rear of the machine.

 3.  With the parking brake engaged, measure the 

compressed spring length of the brake spring.  The 
spring should be 2-1/2” (6,35 cm) when compressed.   
If not, position the lock nut until the measurement 
equals 2-1/2” (6,35 cm).

 4.  Measure the distance between the back of the brake 

pivot link (G) and the front edge of the set collar (F).  
The measurement should be 1/8” (0,32 cm).  If not, 
position the set collar until the measurement equals 1/8” 
(0,32 cm).

Regular Maintenance

Not 

for  

Reproduction