Scag Power Equipment STT-31BSD Manuel D’Utilisation

6. Voltmeter (Figure 4-1).  Indicates the condition of

the charging system.  When the engine is running, in
normal operating conditions, the needle should be in
the 12 to 14 volt range.

7. Oil Pressure (Figure 4-1).  Indicates engine oil

pressure.  Reference the engine operator's manual
for further information.

8. Hourmeter (Figure 4-1).  Indicates the number of

hours the engine has been operated.  It operates
whenever the engine is running.  It can be used to
keep track of maintenance intervals and the amount
of time required to perform various tasks.

9. Fuse Holders (Figure 4-1).  There are two 20-

amp fuses and one 40-amp fuse that protect the
mower’s electrical system.  To replace fuses, pull
fuse out of the socket and install a new fuse.

10. Left Steering Control (Figure 4-1).  Used to

control the mower's left wheel when traveling
forward or reverse.

11. Right Steering Control (Figure 4-1).  Used to

control the mower's right wheel when traveling
forward or reverse.

12. Parking Brake Control (Figure 4-1).  Used to

engage and disengage the parking brakes.  Pull the
lever back to engage the parking brakes.  Push the
lever forward to disengage the parking brakes.

13. Fuel Tank Gauge (Figure 4-1).  Indicates the

amount of fuel in the fuel tank.

Located on the hydraulic pumps, used to “free-
wheel” the mower.  Rotating the levers clockwise
until they stop allows the unit to move under
hydraulic power.  The levers must be in this position
and torqued to 10ft/lbs during operation of the
mower.  Rotating the levers counter-clockwise
allows the mower to be moved by hand (free-
wheeling).

15. Deck Lift Foot Lever (Figure 4-1).  Used to raise

and lower the cutter deck.

16. Cutting Height Adjustment (Figure 4-1).  Used

to set the cutter deck at the desired cutting height.

17. Deck Release Lever (Figure 4-1).  Used to lock

the cutter deck in the transport position.  Push the
foot pedal forward and lift up on the release lever to
release the cutter deck for normal mowing.

18. Temperature Gauge (Figure 4-1).  Indicates the

operating temperature of the engine.

19. Seat Belt (Figure 4-1). Used to secure the

operator. Seat belt must be worn at all times during
operation.

The mower is equipped with a safety interlock system
that prevents the engine from starting unless the deck
drive is disengaged, the parking brake is engaged, the
steering control levers are in the neutral position and the
operator is in the seat.  The interlock system shuts off
the engine if the operator leaves the seat with the
steering control levers not in the neutral position and/or
the cutter blades engaged and the parking brake not
engaged.

390S0141BSG