Scag Power Equipment STT-29DF-SS Manuel D’Utilisation

R

Insert the lanyard pin into the cutting height index at 

3. 

the desired cutting height. Push forward on the deck 
lift foot lever, hold in place and pull back on the deck 
release lever. See Figure 4-6. Slowly release the foot 
pedal. A deck height decal is located on the cutting 
height index as an aid in adjusting the deck to the 
desired height. See Figure 4-5.

CUTTING

HEIG

HT

6

5.5

5

4.5

4

3.5

3

2.5

2

1.5

1

481543

390S0151-1

DECK RELEASE 
LEVER

Position the seat to the desired location.

1. 

While in the operator's position without the engine 

2. 

running, move both steering levers forward and 
reverse to check for full function control and comfort.

If adjustment of the steering levers is needed, use 

3. 

the following instructions to adjust.

A.  Loosen the tension knob on the lever assembly.

B.  Rotate the steering lever forward or backward to 
achieve the optimum operating position.

C.  Tighten the tension knob and repeat on the opposite 
side.

D.  While in the operator's position, bring the steering 
levers  out  of  the  neutral  lock  position  and  check  to 
make sure both levers are even before operating.

The control handle can also be adjusted in two 

4. 

different positions. If necessary, remove the two 
bolts securing the control handle to the control lever. 
Install the handle in the desired position.

Position the seat to the desired location.

1. 

While in the operator's position with out the engine 

2. 

running, push down on the height adjust pedal to 
check for full function control.

The height adjust pedal can be located in three (3) 

3. 

different positions for operator comfort and control. 
See Figure 4-8.

CUTTING

HEIGHT

6

5.5

5

4.5

4

3.5

3

2.5

2

1.5

1

481

54

3

390S0140-2

HEIGHT ADJUSTMENT PEDAL LOCATIONS