Scag Power Equipment SWZV Manuel D’Utilisation

The hydraulic oil filter should be changed after every 500
hours of operation or annually, whichever occurs first.

1. Remove the oil filter element  (Figure 7-3) and

properly discard it.  Fill the new filter with clean oil
and install the filter.  Hand tighten only.

2. Run the engine at idle speed with the speed control

lever in neutral for five minutes.

3. Check the oil level in the hydraulic tank.  Hydraulic

oil must be at the full tab below the filler neck.  If
necessary, add SAE 20w50 motor oil.

The engine oil level should be checked after every 8 hours
of operation or daily as instructed in the Engine
Operator’s Manual furnished with this mower.

After the first 20 hours of operation, change the engine
crankcase oil and replace the oil filter.  Thereafter, change
the engine crankcase oil after every 100 hours of operation
or monthly, whichever occurs first.  Refer to the Engine
Operator’s Manual furnished with this mower for
instructions.

After the first 20 hours of operation, replace the engine oil
filter.  Thereafter, replace the oil filter after every 200
hours of operation or every month, whichever occurs
first.  Refer to Engine Operator’s Manual for instructions.