Scag Power Equipment STT61V-29KB-DF Manuel D’Utilisation
35
R
Section 7
Extinguish all cigarettes, cigars, pipes and other
1.
sources of ignition.
Use only an approved gasoline container.
2.
Never remove the gas cap or add fuel with the
3.
engine running. Allow the engine to completely cool
before fueling.
before fueling.
Never fuel the machine indoors or in an enclosed
4.
trailer.
Never store the machine or fuel container where
5.
there is an open flame, spark or pilot light such as on
a water heater or other appliances.
a water heater or other appliances.
Never fill containers inside a vehicle or on a truck
6.
or trailer bed with a plastic liner. Always place
containers on the ground away from your vehicle
before filling.
containers on the ground away from your vehicle
before filling.
Remove the machine from the truck or trailer and
7.
fuel on the ground. If this is not possible, then refuel
the machine with a portable container, rather than
from a gasoline dispenser nozzle.
the machine with a portable container, rather than
from a gasoline dispenser nozzle.
Keep the nozzle in contact with the rim of fuel tank
8.
or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
complete. Do not use a nozzle lock-open device.
If fuel is spilled on clothing, change clothing
9.
immediately and wash affected skin.
Replace gas cap and tighten securely.
10.
B. REPLACING IN-LINE FUEL FILTER
ELEMENTS
ELEMENTS
The engine fuel filter should be replaced after every 500
hours of operation or annually, whichever occurs first. See
Figure 7-6.
hours of operation or annually, whichever occurs first. See
Figure 7-6.
Close the shut-off valve.
1.
Remove the two clamps securing the fuel filter to the
2.
fuel hose. Remove the fuel filter.
Install a new fuel filter. Be sure it is installed in the
3.
proper direction. Secure to the fuel hose using the
two clamps.
two clamps.
Open the fuel shut-off valve.
4.
C. LPG FUEL SYSTEM
Maintenance must be performed to the LPG fuel system
after 1000 hours of operation or annually, whichever
occurs first. Contact your authorized Scag service center
for details and maintenance. See Engine Owner's manual
for service information
after 1000 hours of operation or annually, whichever
occurs first. Contact your authorized Scag service center
for details and maintenance. See Engine Owner's manual
for service information
Secure loose cylinders when transporting. Transport
1.
in the upright position.
Fill at a reputable dealer.
2.
Do not store tanks (empty or filled) inside any
3.
building or enclosed trailer.
Turn off valve at tank during machine storage.
4.
WARNING
DO NOT overfill. Follow approved procedures for
filling.
filling.
This cylinder is designed to contain LP Gas; a
flammable liquid and gas under pressure.
flammable liquid and gas under pressure.
DO NOT expose to fire or heat above 120 degrees
Farenheit.
Farenheit.
Be sure all fittings are tight and leak proof.
DO NOT attempt repairs. Contact an authorized
LP Gas Dealer.
LP Gas Dealer.
Cylinder must be retested within 12 years of
manufacture date.
manufacture date.
CAUTION
It is important that anyone who changes or uses
this cylinder be aware of its dangerous potential
and use it only in compliance with all applicable
governmental regulations including NFPA No.58
this cylinder be aware of its dangerous potential
and use it only in compliance with all applicable
governmental regulations including NFPA No.58
Cylinders that show excessive denting, bulging,
5.
gouging or corrosion shall be removed from service.
Do not dispose of cylinders with out assistance of
6.
qualified propane personnel.
Replacement cylinders must meet requirements of
7.
original cylinders.
Refuel outdoors.
8.
In cold conditions, 20 degrees F / -6 degrees C and
9.
below, the machine should be started on gasoline
and warmed for 2 minutes, then switched to LP.
Warm engines can be started on LP
and warmed for 2 minutes, then switched to LP.
Warm engines can be started on LP