Euro-Pro UV627 Manuel D’Utilisation

Your Cordless Sweeper will require very little assembly. You should remove it from the 

carton and familiarize yourself with all the components listed as per the exploded view 

drawing (pg.2) This will help you in the assembly and operation of your cordless 

sweeper.

Note: The charging adapter and  the lower handle are shipped inside the dust cup.

Lower Handle

Fig. 1

Fig. 2

If uncertain as to how to remove your battery pack,  we suggest 

you take your sweeper to a reputable small appliance service 

technician to have this service performed.

Follow these steps when battery removal is required. 
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them 

properly. When the batteries are no longer good for use, they must be removed from 

the sweeper for disposal. Do not remove the batteries for any reason other than 

disposal of them. The batteries must be recycled or disposed of in accordance 

WARNING:

You must never use ordinary batteries for replacement as these 
may leak and cause damage. Use only battery pack XBP615

for replacement.

Insert into Lower 

Handle

Fig. 3

1.

In the event that the edging tool is not attached to the sweeper, insert the edging 

tool into the "square" hole under the bottom of the sweeper power head. Gently 

but firmly push until the edging tool locks into place. (Fig. 1)

2.

Insert the lower handle  - small end - into the sweeper power head.  Push until 

firmly in place. (Fig. 2)

3.

Assemble the extension tubes by pushing the plastic insert into the mating extension 

tube. (Fig. 3a) Push until only small portion of insert is visible or you cannot press 

any farther into the tubing. Push the extension tube assembly into the upper handle. 

(Fig. 3)

Insert the extension tube assembly into the lower handle so that the tab on the 

plastic insert snaps into the open slot on the lower handle. (Fig. 3b) 

4.

Place the handle into the upward storage position.

5.

Plug the charging adapter into the sweeper power head charging jack or plug the 

charging adaptor into the charging jack of the charging stand.  If using the charging 

stand, place the sweeper onto the charging stand to charge. Plug the charging 

adapter cord into a standard electrical outlet (120V, 60Hz.) The red charging 

indicator should illuminate. If it does not, depress the On/Off switch one time.

Fig. 3a

Fig. 3b

1.

Remove the extension tube and dust container.

2.

Turn unit over so that the base is facing upwards. Be careful NOT to turn the unit 

ON. (Fig. 19)

3.

Push in locking tab and lift off battery assembly. (Fig. 20)

4.

Place battery assembly aside.

5.

Insert the new battery assembly into unit. Ensure that locking tab snaps in place.

Fig. 19

Fig. 20