Scag Power Equipment SFW36-16BV Manuel D’Utilisation
24
R
Section 7
ENGINE FUEL SYSTEM
7.4
DANGER
To avoid injury from burns, allow the mower
to cool before removing the fuel tank cap and
refueling.
to cool before removing the fuel tank cap and
refueling.
A. FILLING THE FUEL TANk
Fill the fuel tank at the beginning of each operating day
to within one (1) inch below the filler neck. Do not overfill.
Use clean, fresh unleaded gasoline with a minimum octane
rating of 87 and a maximum of 10% Ethanol.
to within one (1) inch below the filler neck. Do not overfill.
Use clean, fresh unleaded gasoline with a minimum octane
rating of 87 and a maximum of 10% Ethanol.
DO NOT use E85 Fuel. Using E85 Fuel will cause severe
damage to the engine.
damage to the engine.
To avoid personal injury or property damage, use extreme
care in handling gasoline. Gasoline is extremely flammable
and the vapors are explosive.
care in handling gasoline. Gasoline is extremely flammable
and the vapors are explosive.
Extinguish all cigarettes, cigars, pipes and other
1.
sources of ignition.
Use only an approved gasoline container.
2.
Never remove the gas cap or add fuel with the
3.
engine running. Allow the engine to completely cool
before fueling.
before fueling.
Never fuel the machine indoors or in an enclosed
4.
trailer.
Never store the machine or fuel container where
5.
there is an open flame, spark or pilot light such as on
a water heater or other appliances.
a water heater or other appliances.
Never fill containers inside a vehicle or on a truck
6.
or trailer bed with a plastic liner. Always place
containers on the ground away from your vehicle
before filling.
containers on the ground away from your vehicle
before filling.
Remove the machine from the truck or trailer and
7.
fuel on the ground. If this is not possible, then refuel
the machine with a portable container, rather than
from a gasoline dispenser nozzle.
the machine with a portable container, rather than
from a gasoline dispenser nozzle.
Keep the nozzle in contact with the rim of fuel tank
8.
or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
complete. Do not use a nozzle lock-open device.
ENGINE OIL
7.3
ENGINE OIL
FILLER
ENGINE OIL
FILTER
FILTER
Briggs & Stratton Engine Oil Fill/Dipstick,
Figure 7-1.
Filter and Drain Locations
A. CHECkING ENGINE CRANkCASE OIL LEvEL
The engine oil level should be checked after every 8 hours
of operation or daily as instructed in the Engine Operator’s
Manual furnished with this mower.
of operation or daily as instructed in the Engine Operator’s
Manual furnished with this mower.
B. CHANGING ENGINE CRANkCASE OIL
After the first 20 hours of operation, change the engine
crankcase oil and replace the oil filter. Thereafter,
change the engine crankcase oil after every 100 hours
of operation or bi-weekly, whichever occurs first. Refer to
the Engine Operator’s Manual furnished with this mower
for instructions.
crankcase oil and replace the oil filter. Thereafter,
change the engine crankcase oil after every 100 hours
of operation or bi-weekly, whichever occurs first. Refer to
the Engine Operator’s Manual furnished with this mower
for instructions.
C. CHANGING ENGINE OIL FILTER
After the first 20 hours of operation, replace the engine
oil filter. Thereafter, replace the oil filter after every 200
hours of operation or every month, whichever occurs first.
Refer to Engine Operator’s Manual for instructions. See
Figure 7-1.
oil filter. Thereafter, replace the oil filter after every 200
hours of operation or every month, whichever occurs first.
Refer to Engine Operator’s Manual for instructions. See
Figure 7-1.