Scag Power Equipment SFZ36-17KA Manuel D’Utilisation

R

Neutral or tracking adjustments will need to be made if:

A.  The  steering  control  levers  are  in  the  neutral 
position and the machine creeps forward or backward. 
(See Neutral Adjustment).

B.  The steering control levers are in the full forward 
position  and  the  mower  pulls  to  one  side  or  the 
other when traveling in a forward direction. (Tracking 
Adjustment, See Page 24).

Be sure the dump valve levers are in the run position 

1. 

and the steering control levers are in the neutral lock 
position.

With an operator in the seat, start the engine and 

2. 

disengage the parking brake.

Run the engine at full operating speed and check if 

3. 

the machine creeps forward or backwards.

Adjust the RH wheel by loosening the jam nuts on 

4. 

the steering control rod and turning the adjustment 
nut until the drive wheel turns in the forward 
direction. Turn the adjustment nut back until the drive 
wheel stops moving. Turn the adjustment nut an 
additional 1/2 turn. See Figure 6-3.

Tighten the jam nuts and repeat for the LH wheel. 

5. 

See Figure 6-3.

Actuate the steering control levers forward and 

6. 

reverse several times and return them to the neutral 
position.

Check that the drive wheels remained in neutral and 

7. 

readjust if necessary.

MOVE STEERING LEVER OUT
TO THE NEUTRAL POSITION

TRACKING ADJUSTMENT
BOLT

ADJUST HERE

LOOSEN THE 
JAM NUT