Woods Equipment CZ2048K Manuel D’Utilisation

Battery acid is caustic and fumes 
are explosive and can cause 
serious injury or death.

To reduce the risk of personal 
injury when working near a bat-
tery:

-   When working with battery 

acid, use protective equipment 
such as, but not limited to, goggles, face shield, 
rubber gloves and apron.

- 

Avoid leaning over a battery.

-  Do not expose a battery to open flames or 

sparks.

-  Be sure batteries with filler caps are properly 

filled with fluid.

- 

Do not allow battery acid to contact eyes or skin.  
Flush any contacted area with water immediately 
and get medical help.

- 

Charge batteries in an open, well ventilated area, 

away from sparks and flames.  Unplug charger 
before connecting or disconnecting from battery.  

- 

Stop the engine and allow to cool before storing.

- 

Drain the fuel tank outdoors only. 

-   Store fuel in an approved container in a cool, dry 

place.

- 

Keep the machine and fuel containers in a locked 
storage place to prevent tampering and to keep 
children from playing with them.

- 

When the machine is to be parked, stored or left 
unattended, lower the cutterdeck unless a posi-
tive mechanical lock is used.

- 

Do not store the machine or fuel container near 

heating appliances with an open flame such as a  
water heater or an appliance with a pilot light.

- 

Keep gasoline storage area free of grass, leaves 

and excessive grease to reduce fire hazard.

- 

Clean grass and debris from cutting units, drives, 

mufflers and engine to help prevent fires.  

1.  Be sure the jumper cables are in good condition.  

Turn off the ignition and all electrical accessories 
on both machines.

2.  Position the machine with a good (charged) bat-

tery next to but not touching the machine with the 
dead battery so jumper cables will reach.  

3.  When making cable connections:

 

-  make sure the clamps do not touch anywhere 

except to intended metal parts,

 

-  Never connect a positive ("+" or red) terminal 

to a negative ("–" or black) terminal.

 

-  Make sure the cables won't get caught in any 

parts after the engines are started.

4.  Connect one end of the first jumper cable to the 

positive terminal on one battery.  Connect the 
other end to the positive terminal on the other 
battery.  

5.  Connect one end of the other cable to the 

negative terminal of the machine with a good 

(charged) battery.  Make the final connection on 
the engine of the machine to be started, away 
from the battery.  

6.  Start the vehicle with the good battery, then the 

machine with the discharged battery.

7.  Remove the cables in the exact reverse order of 

installation.  When removing each clamp, take 
care it does not touch any other metal parts while 
the other end remains attached.

 WARNING