Troy-Bilt Super Bronco Manuel D’Utilisation

7

3. Slide the wheel fully inward on the wheel 
shaft (N, Fig. 2-3). Reinstall the wheel 
drive pin (M) through the wheel shaft only 
(not through the wheel hub). Secure the 
wheel drive pin with the hairpin cotter (L), 
pushing the hairpin cotter in as far as it will 
go. The wheel should now spin freely 
(freewheel) on the wheel shaft. Repeat 
with the other wheel.

4. Use the handlebar to roll the tiller to a 
flat area.

Before starting the engine, 

the wheels must be placed in the WHEEL 
DRIVE position (pins through wheel hubs 
and wheel shaft). This procedure is 
described in Wheel Drive Pins on page 10.

1. Carefully unwrap the forward clutch ca-
ble (cable without an attached knob) from 
its shipping position and slide the thin ca-
ble wire (M, Fig. 2-4) into the slot in the ca-
ble bracket. Push the cable connector (N, 
Fig. 2-4) up through the hole in the bracket 
until the groove in the connector snaps 
into place. 

2. Thread the #10-24 hex nut (Z, Fig. 2-5) 
halfway onto the screw (V) which runs 
through the spring (W, Fig. 2-5). 

3. Thread the screw (V) into the cable ad-
juster (X).