Troy-Bilt 460 Manuel D’Utilisation

Press inward on tab on the engine baffle to release it from 
the baffle bracket. See Fig. 7-3.

Slide belt off of engine pulley and thread through the 
opening in the deck. See Figure 7-4.

NOTE: When removing belt on units with a 25mm adapter, 
the pulleys and washers may also break free from the 
crankshaft. Be sure to make note of the orientation of these 
items for reassembly.

4.

5.

Replace with new belt, making sure belt is firmly seated on 
engine pulley while pulling from the other side and sliding 
it around the transmission pulley.
Reattach engine baffle and reassemble blade as described 
in the previous section.
Turn mower back over and make sure belt is seated on the 
transmission pulley. Pivot the belt keeper wire back into its 
operating position and snap into the slot provided.
Reassemble front drive cover.

The following steps should be taken to prepare your lawn mower 
for storage.

Clean and lubricate mower thoroughly as described in the 
lubrication instructions.
Do not use a pressure washer or garden hose to clean your 
unit.
Coat mower’s cutting blade with chassis grease to prevent 
rusting.
Refer to engine manual for correct engine storage 
instructions.
Store mower in a dry, clean area. Do not store next to 
corrosive materials, such as fertilizer.

When storing any type of power equipment in a poorly 
ventilated or metal storage shed, care should be taken to 
rust-proof the equipment. Using a light oil or silicone, coat the 
equipment, especially cables and all moving parts of your lawn 
mower before storage.

6.

7.

8.

9.

•

•

•

•

•