Tiger Mowers JD 5065M Manuel D’Utilisation

Assembly Section 2-24

Extend the outboard cylinder all the way out.   Adjust the stop adjustment bolt (located 

on the top of the draft beam) out until it is up against the bonnet.   Lock the bolt down with 
the ¾” hex nut.

NOTE:  When the outboard cylinder is fully extended, the bonnet or deck should 

either be up against the stop or if travel locks are installed, it should be up against the 
travel lock.   It may be necessary to use either external or internal slugs on the cylinder to 
get the correct stroke.   If the cutter head is against the stop and the cylinder has stoke 
remaining, serious damage will occur.

Proceed to final preparation for operation instructions on the next page.