Rhino Mounts RHD62 Manuel D’Utilisation

RHD   02/11

Maintenance Section 5-14

© 2011 Alamo Group Inc.

1.

Lift cutter unit to maximum horizontal height;

then, securely support ends of cutterhousing. 

2.

Remove enough knives to place a floor jack

under center of cuttershaft. 

3.

Securely support cuttershaft. 

4.

Remove outboard fender-outboard bearings or

wing drivelines-wing inboard bearings. Loosen
setscrews securing bearing inner race to
cuttershaft. Use special 3/16 hex allen wrench
which has been shortened to reach into
bearings.

5.

Remove fasteners securing bearing and

housing assembly to cutterhousing; then
remove bearing and housing assembly. 

6.

NOTE: There are two tapped holes in the

housing which can be used to pull bearing and
housing assembly out by using special tool No.
701627.

7.

Using a jack to align parts, install bearing and

housing assembly to cutter unit and make
certain that bearing setscrew is located in
keyway on cuttershaft. Grease bearing and
install cap over fitting. 

8.

Replace outboard fender or wing driveline.

Make sure to time wing drivelines properly
before reconnecting.