Jonsered LT2220 CMA2 Manuel D’Utilisation

Park the tractor on level surface.  Engage parking brake.  
BELT REMOVAL -

•  Remove mower from tractor (See “TO REMOVE 

MOW ER” in this section of this manual).

•  Remove screws from RH mandrel cover and remove 

cover.

•  Remove screws from LH mandrel cover and remove 

cover.

•  Work belt off both mandrel pulleys and idler pulleys.
•  Pull belt away from mower. 
BELT INSTALLATION -

•  Install new belt in reverse order of removal. See belt 

routing decal located on right mandrel cover.

•  Make sure belt is in all pulley grooves and in side all 

belt guides.

• 

Install left and right mandrel covers and tighten se cure ly. 

Make sure belt is in mandrel pulley cover.

•  Install mower (see "To install mower" in this section of 

this manual).

If tractor requires more than five (5) feet to stop at highest 

speed in high est gear on a level, dry concrete or paved 

surface, then brake must be serviced.
You may also check brake by:
1.  Park tractor on a level, dry concrete or paved surface, 

depress brake pedal all the way down and engage 

parking brake.

2.  Disengage transmission by placing freewheel control 

in “transmission disengaged” position. Pull freewheel 

control out and into the slot and release so it is held in 

the disengaged position.

The rear wheels must lock and skid when you try to manually 

push the tractor forward. If the rear wheels rotate, then the 

brake needs to be serviced. Contact a qualified service center.

Park the tractor on level surface.  En gage parking brake.  

For as sis tance, there is a belt installation guide decal on 

bottom side of left footrest.
BELT REMOVAL -

•   Remove mower (See “TO RE MOVE MOWER” in this 

section of manual).

NOTE: Observe entire motion drive belt and position of all 

belt guides and keepers.
•   Disconnect clutch wire harness.
•   Remove clutch locator.
•   Remove belt from clutching idler and all stationary 

idlers.

•    Remove belt downward from engine pulley and around 

electric clutch.

•   Pull belt slack toward rear of trac tor.  Carefully remove 

belt up wards from trans mis sion input pulley and over 

cooling fan blades.

BELT INSTALLATION -

•   Carefully work new belt down around transmission 

cooling fan and onto the input pulley. 

•   Pull belt toward front of tractor and roll belt around 

electric clutch and onto engine pulley.

•   Install belt through all stationary idlers  and clutch ing 

idler.

•   Reinstall clutch locator and tighten nut securely.
•   Reconnect clutch harness.
•   Make sure belt is in all pulley grooves and in side all 

belt guides and keep ers.

•   Install mower (See “TO IN STALL MOWER” in this sec-

 tion of manual).

02201