HTC Z5426 Manuel D’Utilisation

English

 -52

LUBRICATION

Check the oil level in the engine when the machine is 

standing level and the engine is stopped. 
Remove the dipstick, wipe it clean, and screw it back 

into place. 
Take the dipstick out again and read the oil level. The 

oil level shall lie between the markings on the dipstick. 

If the level is approaching the “ADD” mark, fill the oil to 

the “FULL” mark on the dipstick. Never fill above the 

“FULL” mark. 
The oil is filled through the hole for the dipstick. 

API class SF, SG, SH, SJ or higher must be used 

Synthetic oil SAE 5W-30 or 10W30 is recommended 

at all temperatures. Mineral oil SAE 5W-30, 10W30 

can be used between 0 °F/-18 °C and 40 °F/+5 °C. At 

temperature above 40 °F/+5 °C single grade SAE 30 

must be used. 
The engine holds 1.5 quarts (1.4 liters) of oil excluding 

the filter; including the filter 1.6 quarts (1.5 liters). 

8011-500

8009-159

8011-739-1

8011-739-1

1.   Drain the engine oil following the procedure 

described in Engine Oil/ Change Engine Oil 

section. 

2.   Remove the oil filter. If necessary, use a filter 

remover. 

3.   Wipe new, clean engine oil on the seal of the new 

filter. 

4.   Mount the filter by hand with + ¾ turn. 

5.   Run the engine warm, to check that there are no 

leaks around the oil filter seal.

Transmission
The transmission is maintenance free and there is no 

need for level checks or oil changes. If a leak occurs, 

replace the unit or contact your Husqvarna dealer.