Husqvarna 435 Manuel D’Utilisation

English

 –

 21

115 10 82-95 Rev.2 2008-04-11

The chain brake should be activated when starting the 
chain saw. Activate the chain brake by pushing the front 
hand guard forwards.

Start position (1): Set the start/stop switch in the choke 
position by pulling the red control outward - upward (1).

Air purge (2): Press the air purge diaphragm repeatedly 
until fuel fills the diaphragm (at least 6 times). The 
diaphragm need not be completely filled.

Grip the front handle with your left hand. Hold the chain 
saw on the ground by placing your right foot through the 
rear handle. Pull the starter handle with your right hand 
and pull out the starter cord slowly until you feel a 
resistance (as the starter pawls engage) then pull firmly 
and rapidly until the engine fires (3).

Push down the red choke control (4) as soon as the 
engine fires which can be heard through a "puff" sound.  
Keep on pulling the cord powerfully until the engine starts.

When the chain saw is heated restart the saw only by 
pulling the cord powerfully until the engine starts (5).

There is a simplified start reminder with illustrations to 
describe each step on the rear edge of the saw (A).

As the chain brake is still engaged the speed of the engine 
must be set to idling as soon as possible, this is achieved 
by disengaging the throttle lock.  Disengagement is done 
by gently touching on the throttle trigger.  This prevents 
unnecessary wear to the clutch, clutch drum and brake 
band.

Then let the machine idle for a few seconds before you 
apply full throttle.

CAUTION! Do not pull the starter cord all the way out and 
do not let go of the starter handle when the cord is fully 
extended. This can damage the machine.