Husqvarna B1100028 Manuel D’Utilisation

SERVICE

5

B1100028

English 2 (5)

Calibration of guide is done automatically first time the mower leaves the charging station in the 

following situations:

•  New mower first start up

•  Always at Test Out

•  After changing guide width to Medium or Wide

•  After performing Factory reset

•  After changing main circuit board

•  After main software update

In mower menu Tools -> Info -> General, the line “Sub-ver” has been added. That software con-

trols the cutting motor. The Sub system software is updated together with the Main and MMI soft-

wares when Automatic programming is done in Autocheck EXP. 

As a result of improved Calibration of Guide some changes have been done in the Test Out and 

Test In procedure.  

•  Test Out must be done before Test In. 

•  If Test In is done before Test Out the mower will run on top of wire to the charging station, 

irrespective of guide width setting. This should not be considered as a valid test. 

 

Demo mode is available in menu Tools -> Special Settings -> Demo Mode. In demo mode  

Automower

®

 305 works without starting the blade disc. The mower varies running with charging at 

four minute intervals.

 

 

 

- It is strongly recommended to use demo mode whenever running Automower

®

 

in public demo areas, for example inside a dealer’s shop. Blade disc is 

switched off in demo mode for increased safety. 

- Always remove the blades from the blade disc whenever Automower

®

 is 

demonstrated in public areas for increased safety.

- Demonstration of Automower

® 

without using demo mode may only be done if 

the mower is constantly under observation.