Husqvarna 968999754 Manuel D’Utilisation
English
-
57
LUBRICATION
Deck Outer Spindle
Lubricate using a grease gun, one zerk, each side 2-3
strokes.
Use only good quality bearing grease.
Use only good quality bearing grease.
Engine Oil
Changing the Engine Oil
The engine oil should be changed for the first time
The engine oil should be changed for the first time
after 5-8 hours of operation. Thereafter, it should be
changed every 50 hours.
1. Place the machine on a flat surface.
2. Place a container under the engine where the hose
2. Place a container under the engine where the hose
from the oil drain valve exits.
3. Remove the dipstick and open the drain valve.
4. Allow the oil to run out into the container.
5. Then close the oil drain valve.
6. Replace the oil filter if necessary.
7. Fill with new engine oil in accordance with
4. Allow the oil to run out into the container.
5. Then close the oil drain valve.
6. Replace the oil filter if necessary.
7. Fill with new engine oil in accordance with
Checking the Oil Level.
8. Start the engine. Run it for a few seconds. Stop
and recheck the oil level.
IMPORTANT INfORMATION
Used engine oil is a health hazard and
Used engine oil is a health hazard and
must not be disposed of on the ground or
in nature; it should always be disposed
of at a workshop or appropriate disposal
location.
Avoid skin contact; wash with soap and
Avoid skin contact; wash with soap and
water in case of spills.
WARNING!
Engine oil can be very hot
Engine oil can be very hot
if it is drained directly after
stopping the engine. Allow
the engine to cool somewhat
first.
Deck outer spindle
8011-733
Oil drain valve
8011-730