Husqvarna Auto Mower Manuel D’Utilisation

English-

46

A number of fault messages are listed below that can 
be shown on the display. If another message than 
those listed is shown, contact your dealer.

Grass or other object may have 
become wrapped around the drive 
wheel.

Check the drive wheel and remove 
the grass or other object.

Grass or other object may have 
become wrapped around the drive 
wheel.

Check the drive wheel and remove 
the grass or other object.

Grass or another object may have 
become wrapped around the blade 
disc.

Check the blade disc and remove the 
grass or other object.

Wrong PIN code has been stated.

State the correct PIN code.

The transformer is not connected to 
the mains supply or its miniature cir-
cuit-breaker has tripped.

Check the wall socket connection and 
whether the miniature circuit-breaker 
has tripped.

Reset the miniature circuit-breaker by 
removing the transformer’s power 
cord from the wall socket, wait 10 
seconds and then reconnect the 
power cord in the wall socket again.

Boundary wire broken.

Check the signal given by the LED on 
the charging station. If it flashes the 
loop is damaged. Repair the broken 
cable using Husqvarna’s waterproof 
connector, part number 535 13 37-01.

If this occurs in isolated areas it may 
be due to interference from metallic 
objects (perimeter fence, reinforce-
ment bar) or buried cables in the 
vicinity. 

Try to move the boundary wire.

If it occurs in the vicinity of an ”island” 
it may be due to the boundary wire be 
routed in the wrong direction around 
”island” and thereby switching off the 
signal.

Check that the boundary wire has 
been routed correctly.

Auto Mower has become caught in 
something.

Free the Auto Mower and rectify the 
reason for it becoming trapped.