Husqvarna R 422Ts AWD Manuel D’Utilisation
English
– 15
Driving
Before starting
•
Read the safety instructions and information concerning
the placement of controls and functions before starting.
the placement of controls and functions before starting.
•
Perform daily maintenance before starting as set out in
the Maintenance schedule.
the Maintenance schedule.
•
Localise and mark stones and other fixed objects to avoid
collision.
collision.
•
Start with a high cutting height and reduce down until the
required mowing results are obtained.
required mowing results are obtained.
•
The mowing result will be best with the highest permitted
engine speed, see technical data, (the blades rotate
rapidly) and low speed (the Mower moves slowly). If the
grass is not too high and thick, the driving speed can be
increased without noticeably depreciating the mowing
result.
engine speed, see technical data, (the blades rotate
rapidly) and low speed (the Mower moves slowly). If the
grass is not too high and thick, the driving speed can be
increased without noticeably depreciating the mowing
result.
•
The best lawns are achieved if the grass is cut often.
Mowing becomes more uniform and the grass cuttings
become more evenly distributed over the surface. The
total time consumption is not greater since it is possible to
select a higher driving speed without inferior mowing
results.
Mowing becomes more uniform and the grass cuttings
become more evenly distributed over the surface. The
total time consumption is not greater since it is possible to
select a higher driving speed without inferior mowing
results.
•
Avoid mowing a wet lawn. The mowing results are inferior
since the wheels sink down into the soft lawn.
since the wheels sink down into the soft lawn.
•
Hose down the cutting unit with water underneath each
time it is used, avoid using a high pressure washer. The
cutting unit should then be put in the service position.
time it is used, avoid using a high pressure washer. The
cutting unit should then be put in the service position.
•
When the BioClip function is used, it is very important that
the mowing interval is not too long.
the mowing interval is not too long.
Start the engine
1
Make sure that the clutch control is depressed. R 422 Ts
AWD have one control for the front axle and one control
for the rear axle.
AWD have one control for the front axle and one control
for the rear axle.
2
Lift up the cutting unit by pulling the lever backwards to
locked position (transport position) and apply the parking
brake.
locked position (transport position) and apply the parking
brake.
The engine can not be started if the parking brake is not
pressed down.
pressed down.
3
Move the throttle control to the middle position.
4
If the engine is cold move the choke lever backwards to its
end position.
end position.
5
Turn the ignition key to the start position.
!
WARNING! Do not use the machine on
ground that slopes more than 10
ground that slopes more than 10
°. Mow
slopes upwards and downwards, never
across. Avoid sudden changes in direction.
across. Avoid sudden changes in direction.
IMPORTANT INFORMATION The air intake grille in the
engine cover behind the driver’s seat must not be blocked
by, for example, clothing, leaves, grass or dirt. Impaired
cooling of the engine. Risk of major engine damage.
engine cover behind the driver’s seat must not be blocked
by, for example, clothing, leaves, grass or dirt. Impaired
cooling of the engine. Risk of major engine damage.
Clear the lawn from stones and other objects which can be
thrown out by the blades.
thrown out by the blades.
2
1