Husqvarna R 422Ts AWD Manuel D’Utilisation

24 – 

English

The machine is equipped with a safety system that prevents 
starting or driving under the following conditions.

The engine must only be possible to start when the following 
conditions are met:

•

The cutting unit is in raised position.

•

The parking brake is applied.

The engine must stop under any of the following conditions:

•

The cutting deck is lowered and the driver rises from the 
seat.

•

The cutting deck is in its raised position, the parking brake 
is not applied and the driver rises from the seat.

Check daily to ensure that the safety system works by 
attempting to start the engine when one of the conditions 
above is not met. Change the conditions and try again.

For information about the bulb type, see Technical Data.

1

Unscrew the two screws holding the cover on the power 
servo housing.

2

Lift up the cover and turn it around the steering shaft.

3

Unscrew the two screws holding the lamp insert.

4

Lift out the lamp insert.

5

Disconnect the cables from the bulbs.

6

Lift out the bulbs from the insert.

7

Insert the new bulbs. Make sure you use your thumb to 
support the front.

8

Refit the cables, lamp insert and the cover on the power 
servo housing.

The main fuse is placed in a detachable holder under the 
battery case’s cover, in front of the battery. Type: Flat pin, 15 
A.

The fuse for the power outlet is placed under the ignition 
switch, behind the side plate on the control panel. Type: Flat 
pin, 7,5 A.

Do not use any other type of fuse when replacing.

A blown fuse is indicated by a burnt connector. Pull the fuse 
from the holder when replacing.

The fuse is there to protect the electrical system. If it blows 
again shortly after replacement, it is due to a short circuit, 
which must be fixed before the machine can be put into 
operation again.