Husqvarna R 422Ts AWD Manuel D’Utilisation
English
– 27
Maintenance
Assembly
1
Fit the front belt on the centre pulley. Pull it on the outside
of the runner wheel and on the inside of the idler pulley.
of the runner wheel and on the inside of the idler pulley.
2
Fit the centre belt on the centre pulley.
3
Reset the cutting unit from service position to mowing
position.
position.
Fitting the cutting head
1
Place the machine on a flat surface and apply the parking
brake. Check that the lever for setting the cutting height is
in the lowest position.
brake. Check that the lever for setting the cutting height is
in the lowest position.
2
Push the equipment frame down and place the catch
against the frame.
against the frame.
3
Remove the drive belt and place it in the belt holder.
4
Push the deck in and put the front guide plugs in the
grooves on the equipment frame, one on each side.
grooves on the equipment frame, one on each side.
5
Push the unit in so that the interior plugs touch the bottom
of the equipment frame’s grooves.
of the equipment frame’s grooves.
6
Lift up the cutting unit
7
Fit the drive belt around the drive wheels of the cutting
unit. Hook up the height adjustment strut.
unit. Hook up the height adjustment strut.
8
Secure the collet spring.
Fit the front cover.
!
WARNING! Wear protective glasses when
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.
trapping your hand.