Husqvarna R 422Ts AWD Manuel D’Utilisation

English

 – 33

Fold up the seat.

Lubricate the lengthways adjustment runners with oilcan.

•

Remove the right side cover on the lever housing (3 
screws) and open the engine cover.

•

Lubricate the cables’ free ends with the oilcan, even those 
by the engine.

•

Move the controls to the end points and lubricate again.

•

Lubricate the joints, catches, and bearings for the cutting 
unit’s control levers with oil.

Replace the lever housing’s side cover.

The belt adjuster should be lubricated regularly using good 
quality molybdenum disulphide grease*.

1

Unscrew the belt shield.

2

Lubricate using a grease gun, 1 nipple from the right-hand 
side under the engine’s lower belt pulley, until grease is 
forced out.

3

 Use only good quality molybdenum disulphide grease.

4

Screw on the belt shield.

* Grease from well-known brand names (petrochemical 
companies, etc.) usually maintains a good quality.

Check the oil level in the engine when the Rider stands 
horizontal with the engine switched off. Do not check the oil 
with the engine running.

Open the engine cover.

Loosen the dipstick, pull it up and wipe it off.

 Now insert the dipstick again, without tightening it.

Pull the dipstick out again and read the oil level.

The oil level should be between the markings on the dipstick. 
If the level is approaching the ADD mark, top up the oil to the 
FULL mark on the dipstick.

The oil is topped up through the hole the dipstick sits in. Fill 
the oil slowly.

Tighten the dipstick correctly before starting the engine. Start 
and run the engine at idling speed for approx. 30 seconds. 
Turn off the motor. Wait 30 seconds and check the oil level. If 
necessary fill so that the oil comes up to the FULL mark on 
the dipstick.

The following oil classes are recommended:

•

API Service Class: SF, SG, SH and SJ