Husqvarna 15Ts AWD Manuel D’Utilisation

24 – 

English

For information about the bulb type, see Technical Data.

1

Loosen the lock nut and remove the Allen bolt. Remove 
the steering wheel.

2

Unscrew the two screws holding the cover on the power 
servo housing. One screw on each side.

3

Press in the parking lock button and lift the cover over the 
steering column.

4

Carefully remove the lamp insert from its two brackets.

5

Disconnect the cables from the bulbs.

6

Lift out the bulbs from the insert.

7

Insert the new bulbs. Make sure you use your thumb to 
support the front.

8

 Refit the cables, lamp insert and the cover on the power 
servo housing.

9

Replace the steering wheel.

The main fuse is placed in a detachable holder under the 
battery case’s cover, in front of the battery.

Type: Flat pin, 15 A.

Do not use any other type of fuse when replacing.

A blown fuse is indicated by a burnt connector. Pull the fuse 
from the holder when replacing.

The fuse is there to protect the electrical system. If it blows 
again shortly after replacement, it is due to a short circuit, 
which must be fixed before the machine can be put into 
operation again.

The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round. 
To improve driving the pressure on the rear tyres can be 
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre 
pressure is 100 kPa (1,0 bar/14 PSI).

Clean the air intake grille in the engine cover behind the 
driver’s seat.

Different tyre pressures on the front tyres will result in the 
blades cutting the grass at different heights.