Cal Spas LTR20091058 Manuel D’Utilisation

2009 Genesis Portable Spa

LTR20091058, Rev. B

9

Overheat protection (spa is shut-

down). One sensor has detected 

118˚F (48˚C) at the heater.

DO NOT ENTER THE WATER!
Remove the spa cover and allow spa to cool below 

107˚F (42˚C).  Press any button on the topside dis-

play to reset spa.  If spa will not reset after spa has 

cooled, turn off power for approximately 30 seconds 

and then turn power back on. If display message is 

repeated then shut the power off to the spa and call 

your dealer or service organization.

When your spa is first actuated, it 

will go into priming mode.

The priming mode will last for up to four minutes and 

then the spa will begin to heat and maintain the water 

temperature in the Standard mode.

Indicates heater is in Sleep Mode.

None.

Spa is shut down. The sensor that 

is plugged into the sensor “A” or 

“B” jack is not working.

If the problem persists, contact your dealer or service 

organization. (May appear temporarily in an overheat 

situation and disappear when the heater cools.)

Sensors are out of balance.

If  this  is  alternating  with  the 

• 

temperature,  it  may  just  be  a 

temporary condition.
If  the  display  shows  only  this 

• 

message (periodically blinking), 

the spa is shut down.

Contact your dealer or service organization.

Indicates heater is in Standard 

Mode.

None.