Nilfisk-Advance America P 150.1 Manuel D’Utilisation

5

•  Never try to clean clothes or foot wear on your self 

or other per sons.

•  Do not let children or people who have not read 

the instruction manual ope rate the ma chine.

•  Never use the machine in an en vi ron ment where 

there could be a danger of ex plo sion. If any doubt 
arises, please contact the local  authorities.

•  It is not allowed to clean asbestos- containing 

sur fac es with high pressure.

Locking device on spray gun
The spray gun features a locking device (6b). When 
the pawl is activated, the spray gun can not be ope-
rated.

Thermal sensor:
A thermal sensor protects the motor against over-
loading. The machine will restart after a few minutes 
when the thermal sensor has cooled.

Pressure safety device
An integrated hydraulic safety valve protects the 
system from excessive pressure 

High pressure

Low pressure

•  Start-/stop rotary switch (2).
•  Spray gun (6) with trigger (6a) and locking device 

(6b). 

•  Dosing regulator for detergents (12).
•  Regulation of pressure / water volume (14). (not 

available on model B)

1. PRO 130/150/160: Attach the high pressure hose 

(5) to the connection for high pressure hose (3).

  Only use one extension hose of max. 7 m.
  PRO 130/150/160 X-TRA: Unwind the high pres-

sure hose completely.

2. Attach the nipple of the high pressure hose to the 

spray gun quick coupling.

3. Mount the nozzle or any other equipment you 

want to use.

4. Connect the machine to the water and power 

supplies.

1. Check that the machine is in vertical po si tion.
2. Activate the trigger of the spray gun (6a) and let 

the water run out until any air has escaped from 
the inlet hose.

3. Turn the start/stop switch (2) to pos. I.

1. 

Always hold the spray lance 
fi rmly with both hands! The spray 
lance is affected by a lon gi tu di nal 
thrust of up to 16.4 N when the high 
pressure washer is ope rated.

2. Point the nozzle at the ground!

3. Activate the trigger of the spray gun (6a).
4. Always 

adjust the distance and thus the pres -

sure of the nozzle to the sur face which is to be 
cleaned. NOTE: The pressure can be reg u lat ed 
on the TORNADO

®

 PR nozzle or the button for 

regulation of pressure / water volume (14).

NOTE: Do not cover the machine during operation. If 
the machine is left or not used for 5 minutes, it must 
be switched off on the start/stop switch (2) pos. O.

Application of detergents is NOT possible if an 
extension hose is applied.
1. Fill the container with a detergent.
2. Mount the TORNADO

® 

PR nozzle and adjust it to 

low pressure (see section 2.4.4).

3. Adjust the dosing regulator (12) to the re quired 

vol ume of detergent (0-5%).

4. Apply the detergent from below and up wards.
5. Let the detergent act for the time stated on the 

packing of the detergent and fl ush with pure water.