Casablanca Fan Company PN9943001 Manuel D’Utilisation

MOTOR

COUPLING

TAPERED

THREAD

MOTOR

WIRES

GROUND

WIRE

Step E. Using the provided allen wrench, loosen the allen set screw.

Thread the downrod into the motor coupling until it stops turning,

this will take at least four and a half full turns.

Step F. Securely tighten the allen set screw with the provided allen

wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the

downrod before securely tightening the

locking bolt may cause the fan to fall during

normal operation!

IMPORTANT SAFETY INFORMATION!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN,

INSTALL THE THREADED DOWNROD INTO THE MOTOR COUPLING AND

LOCK THE ASSEMBLY

ALLEN

SET SCREW

DOWNROD

BALL

ASSEMBLY

Prepare for fan installation as follows:

Step D. Route the wires from the motor through the

Perma•Lock™ downrod and ball assembly, keeping the wires

to one side of the cross pin.

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish

to place your Casablanca fan, an approved ceiling fixture

outlet box must be installed and wired.

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either circuit

breaker or fuse box), lower the old fixture and disconnect

the wiring. Check the ceiling fixture outlet box to be sure

that it is marked ‘Approved for ceiling fan mounting’. If it is

not, a new box must be installed.

Warning: To reduce the risk of fire, electrical shock,

or personal injury, mount to outlet box marked

acceptable for ceiling fan support using the mounting

hardware provided with the outlet box.

NOTE: The fan weight is 35 pounds.

NOTE: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

ALLEN SET SCREW

⁄

-20 x

⁄

”

(PRE-INSTALLED)

3mm

ALLEN WRENCH

FAN PREPARATION

GETTING STARTED