Troy-Bilt 10030 Manuel D’Utilisation

14

The cams on the ends of the control rods which 
interlock the traction drive and auger drive clutches 
must be lubricated at least once a season or every 25 
hours of operation using a multi-purpose automotive 
grease. The cams can be accessed beneath the handle 
panel. See Figure 16.

Follow the instructions below to check the condition of 
the friction wheel rubber every 25 hours of operation.

•

Remove the six self-tapping screws from the frame 
cover underneath the snow thrower.

•

Visually inspect the friction wheel rubber for 
excessive wear, cracks, or loose fit on the friction 
wheel drive hub.

•

Also engage the traction control and check if the 
friction wheel is making contact with friction plate. 
Refer to Figure 10. If it does not make contact, 
adjust the traction drive cable and recheck the 
friction wheel.

•

Replace friction wheel rubber if necessary. Refer to 
instructions on page 16.

Check the condition of the drive belts every 50 hours of 
operation.

•

Remove the plastic belt cover on the front of the 
engine by removing the three self-tapping screws.

•

Visually inspect for frayed, cracked, or excessively 
worn out belts.

•

Replace belts as necessary as outlined in Service 
Section on page 15.

Minor carburetor adjustments may be required to 
compensate for differences in fuel temperature, altitude 
and load. Refer to the engine manual for instructions.

Lube under 
chute base

If any adjustments are made to 

the engine while the engine is running (e.g. 
carburetor), keep clear of all moving parts. Be 
careful of heated surfaces and mufflers.