Troy-Bilt 1030 Manuel D’Utilisation

14

The augers are secured to the spiral shaft with six 
shear pins and cotter pins. See Figure 12 .

1.

If the augers do not turn, check to see if the pins 
have sheared. 

2.

Replace the pins if needed. Two replacement shear 
pins and cotter pins have been provided with the 
snow thrower. Spray an oil lubricant into shaft 
before inserting new pins and securing with new 
cotter pins. See Figure 12.

NEVER replace the auger shear pins with 

standard pins. Any damage to the auger gearbox or 
other components, as a result of doing so, will NOT be 
covered by your snow thrower’s warranty.

The shave plate and skid shoes at the bottom of the 
snow thrower are subject to wear. Check these 
periodically and replace as necessary.

1.

Remove the four carriage bolts and lock nuts which 
attach the two skid shoes to the snow thrower on two 
sides. See Figure 13 .

2.

Reassemble new skid shoes with the same 
hardware. Make certain the skid shoes are 
adjusted to be level.

1.

After removing both skid shoes, remove four 
carriage bolts and lock nuts which attach shave 
plate to the snow thrower housing. See Figure 13 . 
The shave plate and skid shoes at the bottom of the 
snow thrower are subject to wear. Check these 
periodically and replace as necessary. 

2.

Reassemble new shave plate, making sure heads 
of the carriage bolts are to the inside of the housing. 
Tighten securely. Re-install skid shoes.

Check the condition of both auger belt and drive belt 
every 25 hours of snow thrower operation. Replace if 
either shows signs of wear and tear. To remove and 
replace either the auger belt or the drive belt, follow the 
steps below and then proceed to the specific steps 
listed under respective sub-headings.

1.

Remove belt cover by removing the two self-
tapping screws that secure it to the snow thrower 
housing. See Figure 14A.

2.

Take auger belt off the pulley following Figure 14B.

Always stop engine, disconnect 

spark plug wire and move it away from spark 
plug before performing adjustments or repairs. 
Always wear safety glasses during operation or 
while performing any adjustments or repairs.