Troy-Bilt 1030 Manuel D’Utilisation

8

Read this owner’s manual and safety rules before operating your snow thrower. Compare Figure 8 with your snow 
thrower to familiarize yourself with the location of various controls and adjustments. Maintain safety while learning 
about the controls and operating the unit. Save this manual for future reference. 

The drive control is located on the right handle. 
Squeeze down the drive control to engage the wheel 
drive. Release to stop. 

The drive control also locks the auger control so you 
can operate the chute directional control without 
interrupting the snow throwing process. If the auger 
control is engaged simultaneously with the drive 
control, the operator can release the auger control (on 
the left handle) and the augers will remain engaged. 
Release both controls to stop the augers and wheel 
drive.

 Always release the drive control before 

changing speeds.

The auger control is located on the left 
handle. Squeeze the auger control to 
engage the augers. Release to stop the 
snow throwing action. The drive control 
must also be released in order to stop 
the auger.

Refer to Auger Control Test on page 6 prior to 

operating your snow thrower. Read and follow all 
instructions carefully and perform all adjustments to 
verify your snow thrower is operating safely and 
properly.

The ignition key must be inserted and snapped in place 
in order for the engine to start. Remove the ignition key 
to prevent unauthorized use of equipment. Do NOT 
attempt to turn the key.