Teledyne 701 Manuel D’Utilisation

MAINTENANCE 

Teledyne API Model 701 Zero Air Generator 

6-4 

01671H (DCN6051) 

1.  Turn off power and unplug the M701. 
2.  Disconnect the CO-CO

2

 scrubber at the Controller. 

3.  Lift out the scrubber by removing the two screws under the chassis and the two 

pneumatic fittings. 

The scrubber will be hot. 

 

4.  Allow the scrubber to cool. 
5.  Lift the cartridge from the white insulator by removing the two screws underneath. 
6.  With a 9/16” wrench, remove the two unions from the top of the scrubber cartridge. 
7.  Pick out the retaining screens. 
8.  Shake out the catalyst beads and dispose. No special disposal methods required. 
9.  Pour in new catalyst to 1/2” from the top of the bores. Tap the cartridge sides gently 

to settle the beads and top up to the 1/2” level. 

10. Replace the retainer screens. 
11. Replace the TFE tape on the two unions and replace the unions in the cartridge. 
12. Reassemble the scrubber, replace it in the chassis and reconnect the tubing and 

receptacle. 

13. Turn on the M701 and leak check using soap solution. 

If the unit has the HC scrubber option it will also have a CO scrubber attached to the 
CO scrubber housing. This is not a heated scrubber. It is held in place with 4 screws 
through the body of the scrubber into the CO scrubber housing. Remove these 4 screws 
to remove the scrubber. Follow steps 5 through 13.