Multiquip C1870300404 Manuel D’Utilisation

There are two 120 VAC, 20 amp GFCI  (Duplex Nema 5-20R)
recepacles provided on the output terminal panel.  These
receptacles can be accessed in any 

position.  Each receptacle is protected by a 20 amp circuit
breaker. These breakers are located directly above the GFCI
receptacles. Remember the load output (current) of both
GFCI receptacles is dependent on the load requirements of
the U, V, and W output terminal lugs.

Pressing the 

reset button resets the GFCI receptacle after

being tripped.   Pressing the 

Test Button (See Figure 10) in

the center of the receptacle will check the GFCI function.
Both receptacles should be tested at least once a month.

Each auxilliary receptacle is protected by a 50 amp circuit
breaker. These breakers are located directly above the GFCI
receptacles. Remember the load output (current) on all three
receptacles is dependent on the load requirements of the
Output Terminal  Lugs.

Turn the 

voltage regulator control knob  (Figure 12) on the

control panel to obtain the desired voltage. Turning the knob
clockwise will

 increase the voltage, turning the knob counter-

clockwise will 

decrease the voltage.

There are three 240/139V, 50 amp auxilliary twist-lock
(CS-6369) recepacles (Figure 11) provided on the output
terminal panel.These receptacles can 

only be accessed

when the voltage change-over board is configured for  

The 

Output Terminal  Lugs are protected by a plastic face

plate cover (Figure 13). Un-screw the securing bolts and lift
the plastic terminal cover to gain access to the terminal
enclosure.

After the load wires have been securely attached to the
terminal lugs, reinstall the plastic face plate.