Multiquip C1870300404 Manuel D’Utilisation

To shutdown the generator use the following procedure:

1. Place both the MAIN, GFCI and LOAD circuit breakers

as shown in Figure 39 to the OFF position.

2.  Place the engine speed switch (Figure 56) in the “

LOW ”

(down) position.

5. Verify that the 

all status LED on the MPEC display

are OFF (not lit).

6. Remove all loads from the generator.

7. Inspect entire generator for any damage or loosening of

components that may have occured during operation.

1.   To  shut-down the engine in the event of an emergency,

push the 

Emergency Stop Button (Figure 58).

2. Switch the 

MAIN, GFCI and LOAD (Figure 38) circuit

breakers to OFF position.

3. Let the engine cool by running it at low speed for 3-5

minutes with no load applied.

4. Place the 

MPEC Control Switch (Figure 57) to the

OFF/RESET position.

NEVER stop the engine suddenly except in an emergency.

ALWAYS make sure the diagnostic switch is placed in the
OFF position before attempting to shut down the generator.
The  OFF/RESET switch on the MEC controller will not
shut down the generator if the diagnostic switch is left in
the ON position.