Crate Amplifiers PM82S Manuel D’Utilisation
1. PEAK LED: This LED illuminates when the input signal
nears clipping. During normal operation, this LED will flash
on strong signal peaks. If the LED remains illuminated,
depress the Pad switch (#9) and/or reduce the level of the
signal connected to the input jack (#10,11).
on strong signal peaks. If the LED remains illuminated,
depress the Pad switch (#9) and/or reduce the level of the
signal connected to the input jack (#10,11).
2. HIGH: Use this control to adjust the high frequency level
for the channel.
3. MID: Use this control to adjust the midrange frequency
level for the channel.
4. LOW: Use this control to adjust the low frequency level for
the channel.
5. MON: Use this control to adjust the amount of the chan-
nel’s signal sent to the monitors.
6. EFFECT: Use this control to adjust the amplitude of the
internal DSP effect (or external effects, if used) to be
applied to the channel’s signal.
applied to the channel’s signal.
7. PAN: Use this control to adjust the left-to-right balance of
the channel’s signal.
8. LEVEL: Use this control to adjust the channel’s output sig-
nal level.
9. PAD: Use this switch to accommodate “hot” input signals.
(Signals too strong to allow a useful setting of the gain con-
trol without causing the Peak LED - #1- to remain illuminat-
ed.) Depress this switch to engage the 20dB pad, thereby
reducing the input signal’s level to a more useable range.
trol without causing the Peak LED - #1- to remain illuminat-
ed.) Depress this switch to engage the 20dB pad, thereby
reducing the input signal’s level to a more useable range.
10. HIGH-Z LINE: Use this jack to connect the output signal
from a high impedance microphone or a line level signal
(such as an instrument, rhythm machine, tape deck, etc.)
to the mixer by means of a shielded cable terminated with
a male 1/4” plug. Tip = “+,” ring = “–,” sleeve = shield.
(such as an instrument, rhythm machine, tape deck, etc.)
to the mixer by means of a shielded cable terminated with
a male 1/4” plug. Tip = “+,” ring = “–,” sleeve = shield.
11. MIC: Use this jack to connect the output signal from a low
impedance microphone to the mixer by means of a shield-
ed cable terminated with a male XLR plug. Pin 2 = “+,” pin
3 = “–,” pin 1 = shield.
ed cable terminated with a male XLR plug. Pin 2 = “+,” pin
3 = “–,” pin 1 = shield.
The Mono Input Channels:
1
2
3
4
5
6
7
8
9
10
11
4
PM62S/PM82S/PM82T Powered Mixers