Yamaha MOTIF XS7 Manuel D’Utilisation

From this display, you can set the control functions for the 
Knobs, and the up/down range for the Pitch Bend wheel. 

Determines which lamp among the TONE 1, TONE 2, ARP 
FX, REVERB, CHORUS and PAN is turned on when 
selecting a Performance. This setting can be stored for 
each Performance. 

Settings: tone1, tone2, ARP FX, reverb, chorus, pan

Indicates the level of the Knobs printed “ASSIGN1” and 
“ASSIGN2” at the time at which the Performance is 
selected with the TONE1 lamp turned on. The functions 
assigned to the Knobs are indicated at right of the values 
respectively. 

Settings: -64 – +0 – +63

n The functions assigned to the ASSIGN 1/2 Knobs can be set in 

the Controller Set display (page 104). 

Determines whether the ASSIGNABLE FUNCTION [1] and 
[2] buttons functions as a latch type or momentary type. 
When set to “latch,” pressing the button alternates the 
lamp status between on and off. When set to “momentary,” 
pressing/holding the button turns the lamp on and 
releasing the button turns the lamp off. 

Settings: momentary, latch

Determines the behavior of the Ribbon Controller. When set 
to reset, releasing your finger from the Ribbon Controller 
automatically returns the value to the center. When set to 
hold, releasing your finger from the Ribbon Controller 
maintains the value at the last point of contact. 

Settings: hold, reset

Determines whether Arpeggio is on or off. This parameter 
is the same as the Common Switch parameter in the 
Arpeggio display (page 139) of the Performance Play 
mode.

This parameter is the same as the Sync Quantize Value 
parameter in the Arpeggio display (page 139) of the 
Performance Play mode.

Determines the output level of the entire Performance. You 
can adjust the overall volume, keeping the balance 
between all Parts. 

Settings: 0 – 127

Determines the stereo pan position of the Performance. 
You can also adjust this parameter using the PAN knob on 
the front panel. 

Settings: L63 (far left) – C (center) – R63 (far right)

n Note that this Performance Pan parameter may have little or no 

audible effect if the Pan for a specific Part is set to the left 
position and the Pan for another Part is set to the right position. 

Adjusts the reverb send level. The higher the value the 
deeper the reverb. You can also adjust this parameter 
using the knob on the front panel.

Settings: 0 – 127

Adjusts the chorus send level. The higher the value the 
deeper the chorus. You can also adjust this parameter 
using the knob on the front panel. 

Settings: 0 – 127

n When Reverb Send/Chorus Send is set to “0” in the 

Performance Part Edit mode, the setting here is not available.