Yamaha MOTIF XS7 Manuel D’Utilisation

This Job lets you delete a specific Waveform from memory. 
The Key Banks and Samples included in the Waveform are 
also deleted. 

Determines the Waveform number to be deleted. 

This Job lets you delete all unnecessary parts of the 
Sample (located ahead of the Start Point and located after 
the End Point). 

Determines the Waveform number to be extracted. 

This Job lets you transpose the Key Bank setting of a 
specified Waveform in semitones or in octaves. 

Determines the Waveform number to which this Job is 
applied. 

Determines the amount in octaves by which the Key Bank is 
transposed. When you want to transpose by less than one 
octave, set this to “0” and use the Note parameter below. 

Settings: -3 – +0 – +3

Determines the amount in semitones by which the Key Bank is 
transposed. When you want to transpose by exact octaves, 
set this to “0” and use the Octave parameter above. 

Settings: -11 – +0 – +11

This Job lets you assign a name to the selected Waveform. 

Determines the Waveform number to which this Job is 
applied. 

Determines the Waveform name which can contain up to 
10 characters. For detailed instructions on naming, refer to 
“Basic Operation” on page 82. 

This Job optimizes the memory (DIMM) for Sampling. 
Optimization consolidates areas of used and unused 
(available) memory to create the largest possible area of 
contiguous available memory. In some cases, the amount 
of remaining memory will be increased when you execute 
the Optimize Memory Job. 

This Job deletes all the user Waveforms. The Key Banks 
and Samples included in the Waveform are also deleted. 

Start point

End point

Extract

Start point

End point