Yamaha MOTIF XS7 Manuel D’Utilisation

This Job lets you change the values of specified data such 
as Pitch Bend and Control Change in the specified range. 
Data changes are calculated as follows: 

Modified value = (original value x Rate) + Offset.

Any result lower than the minimum is set to the minimum; 
any result higher than the maximum is set to the maximum. 

Determines the Song track (01 – 16, tempo, all) and range 
(Measure : Beat : Clock) over which the Job is applied.

Determines the event type to be modified. 

When the Track is set to one of 01 – 16 and all:

Pitch Bend, CC & Ch. Mode (Control Change and Channel Mode 
Message)*, Ch. After Touch (Channel Aftertouch), Poly After Touch 
(Polyphonic Aftertouch)
*You can also specify the Control Number (0 – 127, all)

When the Track is set to “tempo”:

Tempo Change

Sets all target events to the same fixed value. When set to 
“off” the Set All parameter has no effect. When set to a 
value other than “off,” the Rate and Offset parameters are 
unavailable and cannot be set. 

Settings: off, 000 – 127 (off, -8192 - +8191 when the Event Type is set 

to “Pitch Bend” and off, 5.0 – 300.0 when the Event Type is 
set to “Tempo Change.”)

Determines the percentage by which the target events will 
be shifted from their original values. When the Set All 
parameter (above) is set to other than “off,” this parameter 
cannot be set. 

Settings: 000% – 200%

Adds a fixed value to the Rate-adjusted event values. 
When the Set All parameter (above) is set to other than 
“off,” this parameter cannot be set. 

Settings: -127 – +127 (-8192 – +8191 for pitch bend)

This Job performs time-expansion or compression over the 
selected range. 

Determines the Song track (01 – 16, tempo, all) and range 
(Measure : Beat : Clock) over which the Job is applied.

Determines the amount of time expansion or compression 
as a percentage. Settings higher than 100% produce 
expansion, and settings below 100% produce 
compression. A setting of 100 produces no change. 

Settings: 025% – 400%

n Only the end point of the range will be shifted forward or 

backward by executing the Beat Stretch Job. The data outside 
the specified range will be maintained. When expanding the 
data, the converted data may overlap the data outside the 
range. When compressing the data, an interval of silence will 
be created between the end of the compressed data and the 
start of the next data outside the range. 

This Job creates empty measures at the specified location 
in all tracks. When empty measures are inserted, measure 
and meter data following the insert point are moved 
forward accordingly. If the insert point is set after the last 
measure containing data, only the meter data at that point 
is set without actually inserting any measures.