Sony 2-190-733-11 (1) Manuel D’Utilisation
24
To Control the Projector Whose Protocol Is Not Preset to the Mixer
a Click the TEST button in the PROJECTOR
POWER STANDBY section on the PROTOCOL
SETTING screen and check that the projector
enters standby status.
SETTING screen and check that the projector
enters standby status.
b Click the TEST button in the PROJECTOR
POWER ON section and check that the projector
turns on.
turns on.
c Press the AV/RGB SELECT A button on the
mixer and check that the video signal is output to
the projector.
the projector.
d Click the TEST button in the PROJECTOR
POWER STANDBY section, then after about 3
seconds, click the TEST button in the
PROJECTOR POWER ON section.
seconds, click the TEST button in the
PROJECTOR POWER ON section.
e Check that the projector enters standby status.
f Check that the projector turns on after the wait
f Check that the projector turns on after the wait
time specified by the WAIT input box elapses and
the video signal output to the AV/RGB INPUT A
connector is input to the projector.
the video signal output to the AV/RGB INPUT A
connector is input to the projector.
When the projector does not enter standby status,
check that the command entered in the command
input section is correct.
When the projector does not turn on, repeat the test by
increasing the wait time to be input to the WAIT input
box in 1-second steps until the projector operates
correctly.
check that the command entered in the command
input section is correct.
When the projector does not turn on, repeat the test by
increasing the wait time to be input to the WAIT input
box in 1-second steps until the projector operates
correctly.