M-AUDIO 2626 Manuel D’Utilisation

User Guide

46

ProFire 2626

 

 Possible Cause 1: Power supply not connected   Verify that the ProFire 2626 power supply is properly 
attached to the interface and plugged into a working AC outlet   Next, make sure the interface is powered on 
using the Power Button (9) 

 

 Possible Cause 2: Improper connection to external devices   Verify that the analog outputs of ProFire 2626 
are properly connected to the inputs of an appropriate device (such as a mixer, amplifier, or powered monitors) 
using good cables   If you are connecting digitally to a digital device such as a DAT recorder or digital mixer, 
make sure you are using proper digital cables and that the device is configured to receive signals from ProFire 
2626   Finally, verify that the interface is properly connected to your computer using the supplied FireWire 
cable 

 

 Possible Cause 3: The ProFire 2626 device drivers are not properly installed   See the installation instructions 
in the printed ProFire 2626 Quick Start Guide for further information 

 

 Possible Cause 4: There is a resource conflict between the ProFire 2626 and another device in your 
computer   Try the following to see if the issue resolves:

 

 

a    If your computer has multiple FireWire ports, try connecting ProFire 2626 to a different port 

 

 

b     If you have other FireWire devices connected to your system, try disconnecting those devices and 

rebooting the computer 

 

 

c     If there are PCI cards installed in your computer, remove other PCI cards from your system one at a 

time to see if a FireWire resource conflict can be traced to a specific PCI slot or card in your system 

 

 

d     If ProFire 2626 is sharing FireWire resources with other FireWire devices (i e , hard disks, other 

interfaces, etc ), the FireWire bus may be overloaded with data   To resolve this issue, disable any 
software returns you are not using from the Settings tab of the Control Panel   This may free up 
bandwidth at the FireWire bus allowing audio to stream properly   If this does not bring the desired 
results, try removing the other FireWire devices from your computer to free up FireWire bus bandwidth 

 

 

e     Windows Users:  If your computer includes a built-in sound card, turn it off   This is usually done 

through the system BIOS or by changing a hardware jumper on the motherboard   See your 
computer’s documentation for more information about this 

 

  

 If these steps do not resolve your problems, please see the Support > Knowledge Base page on www m-
audio com for additional information 

 

 Possible Cause 5: Your audio application has not been configured to use ProFire 2626 as its audio input/
output device   Refer to your software’s documentation to learn how to do this 

 

 Possible Cause 6: Your audio outputs have been misrouted in the ProFire 2626 Control Panel   Check the 
Control Panel’s Router page to verify the output routing assignments   Also, if you are monitoring the outputs 
of ProFire 2626’s DSP Mixer, make sure that the mixer’s faders, solo, and mute controls are set properly 

11