Tapco MIX10FXP Manuel D’Utilisation

This two-position switch 

lets you choose which signal 
paths from the mixer section 
are sent to the internal power 
amplifi ers. It only affects the 
speaker-level outputs (3).
Stereo Mains

 

In the upper switch position, the output 
from channel A is the left side of the 
main mix, and the output from channel 
B is the right side of the main mix. 
Choose this position to play a stereo 
show.

 

In the lower switch position, channel A 
is the main mix (in mono), and channel 
B is the monitor mix. In this setup, you 
could run a mono PA system on channel 
A, and a passive stage monitor system 
on channel B.

These 1/4" TS unbalanced inputs allow you 

to connect line-level signals directly to the 
input of the internal power amplifi ers.

The internal amplifi ers will then only play 

the audio that enters here from the outside 

world. The master level (28), graphic EQ 
(25), and amp mode switch [12] will have 
no effect, and the meters (26) will not show 
the levels. Only the series 69 EQ switch [33] 
will affect the output. Plugging anything into 
these inputs does not affect the line-level 
outputs.

You could patch a device between the 

main outputs [11] and these inputs, in which 
case, the controls and meters will work, 
except for the amp mode switch.

These inputs are also useful when you 

need more channels than the powered 
mixer provides. You could connect the line-
level outputs from an external mixer, and 
use this external mixer to control the mix 
and levels playing in loudspeakers attached 
to the powered mixer. You could also 
connect the main line-level outputs (11) to 
the external mixer to merge the powered 
mixer’s channels and the external mixer’s, 
for even more channels.

The external mixer or device will 
control the volume, so turn it down 
at fi rst, or the powered mixer may 
come on at full volume.