iOptron IEQ30 Manuel D’Utilisation
2
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com
Quick Setup
1. Setup tripod
: Expand the tripod legs and lock the
Tripod Support so that the tripod legs stay open (Figure
1). Adjust the tripod height by unlocking and re-locking
the tripod legs to desired height. Position the tripod so
that the Alignment Peg faces south. (The Alignment
Peg may be moved to the opposite position if used
at latitude lower than 20º to avoid counterweights
hit the tripod leg )
1). Adjust the tripod height by unlocking and re-locking
the tripod legs to desired height. Position the tripod so
that the Alignment Peg faces south. (The Alignment
Peg may be moved to the opposite position if used
at latitude lower than 20º to avoid counterweights
hit the tripod leg )
Figure 1
2. Attach the iEQ30 Mount:
If the latitude is between 25º to 65º, set the Position Safety Pin at High Latitude Position,
as shown in Figure 2 (a). For latitude between 0º to 35º, set the Position Safety Pin at Low Latitude Position, as
shown in Figure 2 (b). Install the matching Latitude Adjustment Knob as well. The factory set default position is High
Latitude Position (25º ~ 65º).
shown in Figure 2 (b). Install the matching Latitude Adjustment Knob as well. The factory set default position is High
Latitude Position (25º ~ 65º).
Retract the Azimuth Adjustment Knobs (refer to Figure 3 in which is next to the Bubble Level Indicator) to allow
enough clearance for the Alignment Peg seating in the house. Unscrew 2 Azimuth Locking Screws. Put the mount
onto the tripod head with bubble level on top of the Alignment Peg (Figure 3). Put the Teflon washer and Azimuth
Locking Screws back and tighten them. Level the tripod base by adjusting individual leg. You may use the build-in
Bubble Level Indicator or an external torpedo level to check level.
enough clearance for the Alignment Peg seating in the house. Unscrew 2 Azimuth Locking Screws. Put the mount
onto the tripod head with bubble level on top of the Alignment Peg (Figure 3). Put the Teflon washer and Azimuth
Locking Screws back and tighten them. Level the tripod base by adjusting individual leg. You may use the build-in
Bubble Level Indicator or an external torpedo level to check level.
High Lat. Position
Lat. Adj. Knob (25º~65º)
Lat. Adj. Lever
Low Lat. Position
Lat. Adj. Knob (0º~35º)
Figure 2
Alignment Peg
Azi. Adj. Knob
Bubble Level
Figure 3
3. Set the Location Latitude:
Unlock R.A. Clutch and adjust the mount upright. Tighten the R.A. Clutch. Unscrew four
Latitude Locking Screws. Turn the Latitude Adjustment Knob to set your current latitude (Figure 2), which is displayed
in Latitude Mark Window on the side of the mount. Using the Lever for a fine adjustment if needed.
in Latitude Mark Window on the side of the mount. Using the Lever for a fine adjustment if needed.
4. Install Counterweight (CW) Shaft:
Unscrew the CW shaft from the top of the mount (Figure 4 left) and thread it into
the opening of the DEC axis (Figure 4 right).
Figure 4
(b)
(a)