Polaris 280 Manuel D’Utilisation

Installs in minutes on pools with a dedicated cleaner return line and a threaded 1-1/2” female
pipe fitting.

1.

Turn on the filtration pump and flush out the plumbing line.Turn pump off.

2.

Remove the UWF from the Quick Disconnect and screw the UWF with the blue restrictor
disk into the return opening.

3.

Turn the Quick Disconnect clockwise into the UWF and pull away to secure.

Measure the deepest part of the pool. Cut leader hose, from end that attaches to feed hose, so
length is equal to the greatest depth of the pool.

Attach leader hose to feed hose and connect hose to the pool wall at the return line. Extend
hose to farthest point of pool. The hose end must be within 6" – longer or shorter – of the
farthest point. See dotted circle.

Hose too long? Separate hose at center swivel. Cut equal amounts of the overage from
each 10-foot feed hose section.

Hose too short? Buy an additional feed hose section (part #9-100-3104), one swivel (part
#D20) and two hose nuts (part #D15) from an authorized Polaris dealer.

After adjusting hose, position hose floats as shown.

www.polarispool.com

Universal Wall Fitting

Quick Disconnect

Pressure Relief Valve

Return Line

Restrictor Disk

 Leader Hose Floats

2-3' apart

Return 
Line

Feed Hose Floats 

1.5 to 3' apart

Center

Swivel

Leader Hose 

Length = Max. Depth

In-Line 
Filter