Grizzly G0619 Manuel D’Utilisation

G0619 DELUXE SMALL MILL/DRILL

-13-

Feet

Four  leveling  feet  have  been  included  with  your
mill/drill.  However,  for  greater  safety  and  bet-
ter  performance,  we  recommend  bolting  your
machine to a sturdy workbench.

Components and Hardware Needed:

Qty

Feet with Hex Nut M12-1.75 ............................... 4

To adjust the feet on the mill/drill:

1. Place your precision level on the mill/drill

table.

2. Adjust the hex nut(s), as shown in Figure

7, until the mill/drill is level side-to-side and
front-to-back

Figure 7. Leveling the mill/drill.

Hex Nut

Mounting to

Workbench

Your mill/drill should be bolted to a workbench to
provide maximum rigidity and safety.

Components and Hardware Needed:

Qty

Hex Bolts M12-1.75 x (length as needed) ...........4
Flat Washers 12mm ...........................................8
Lock Washers 12mm ..........................................4
Hex Nuts M12-1.75 .............................................4

To mount the mill/drill to the workbench:

1. Determine the best position for the mill/drill

on the workbench.

Note:  For  the  best  performance,  make
sure  the  cross  feed  and  the  longitudinal
handwheels  extend  out  beyond  the  edge  of
the table surface. This will allow unrestricted
handwheel operation.

2. Mark your hole locations using the mounting

holes in the base as a guide.

3. Drill the holes needed in the workbench.

4. Place a precision level on the mill/drill table

and shim the mill/drill until it is level side-to-
side and front-to-back.

5. Bolt the mill/drill to the top of the workbench

(

Figure 8 ).

��

��

Figure 8. Example of a through mount setup.