Emerson 20/20 Manuel D’Utilisation
14 – 1
Vission 20/20 • Operation and Service Manual •Vilter/Emerson • 35391SC 1.8.5153
Section 14 • Slide Calibration
Overview
The Slide Calibration screen is used in calibrating the
slide actuators and to establish Vission 20/20 control
parameters. It is important that the operator uses cau-
tion while operating in this screen, see Figure 14-1. Slide
Calibration Screen. The normal safety checks that pre-
vent the slide from colliding with the mechanical stops
are overridden. When the calibration process is complet-
ed and the operator exits the screen, Both actuator will
return the slides back to their minimum positions.
slide actuators and to establish Vission 20/20 control
parameters. It is important that the operator uses cau-
tion while operating in this screen, see Figure 14-1. Slide
Calibration Screen. The normal safety checks that pre-
vent the slide from colliding with the mechanical stops
are overridden. When the calibration process is complet-
ed and the operator exits the screen, Both actuator will
return the slides back to their minimum positions.
Capacity Slide Valve Potentiometer
This section provides critical information and control pa-
rameters related to the capacity slide actuator. The “%
cap” display shows the actual value in percent of the ca-
pacity slide with out any conditioning that might be ap-
plied to the other capacity position displays. In addition,
rameters related to the capacity slide actuator. The “%
cap” display shows the actual value in percent of the ca-
pacity slide with out any conditioning that might be ap-
plied to the other capacity position displays. In addition,
this section displays the value of the actuator signals in
millivolts in the “input Value” display box.
“-” Button:
• When the operator presses and holds this button,
millivolts in the “input Value” display box.
“-” Button:
• When the operator presses and holds this button,
the output associated with capacity slide decrease
is energized. If the actuator does not turn in the cor-
rect direction when this button is pressed, then the
operator will have to alter how the actuator is wired
to the panel.
is energized. If the actuator does not turn in the cor-
rect direction when this button is pressed, then the
operator will have to alter how the actuator is wired
to the panel.
“+” Button:
• When the operator presses and holds this button,
• When the operator presses and holds this button,
the output associated with capacity slide increase is
energized. If the actuator does not turn in the cor-
rect direction when this button is pressed, then the
operator will have to alter how the actuator is wired
to the panel.
energized. If the actuator does not turn in the cor-
rect direction when this button is pressed, then the
operator will have to alter how the actuator is wired
to the panel.
Software limit setpoint:
• The Vission 20/20 uses the “Min Limit” and
• The Vission 20/20 uses the “Min Limit” and
“Max Limit” setpoint to defi ne an area within the
Figure 14-1. Slide Calibration Screen