Makita BCG180 Manuel D’Utilisation

P  8/ 11

ASSEMBLING

(9) When replacing the whole Gear assembly, use new Gear assembly as drawn in Fig. 12.

(8) Assemble the driving section (Gear assembly and Motor complete) to Housing (L) complete as drawn in Fig. 11.

Compression spring 6

3. Gear assembly is pushed by Compression spring 6

    toward Sub controller, and it may not be fitted

    within the rib on Housing (L) complete at the motor

    portion. So, push Gear assembly toward the direction

    of the black arrow shown below to set it within the rib.

Compression spring 6

Rib

Magnet

Magnet

Rib 

Sub controller

Compression 

spring 6

1. Mount Compression spring 6 to Magnet

    in Gear housing.

4. Make sure that Compression spring 6

    fits inside the space.

2. Fit Compression spring 6 to the rib on

    Housing (L) complete with pressing

    it toward Magnet.

1. Remove three 3x16 Tapping screws and Gear housing cover from Gear assembly. 

2. Assemble Motor complete with Gear housing cover to new Gear assembly 

    with three 3x16 Tapping screws.

Note: Scrap Removed Gear housing cover and three 3x16 Tapping screws. 

Motor complete

Gear housing cover

(the component of Motor complete)

3x16 Tapping screw (3 pcs.)

Main body of

Gear assembly