Cisco Systems 2130 Manuel D’Utilisation
3-6
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance
Mounting the Cisco ADE 2130 and 2140 Series Appliance in a 2-Post Rack
Installing the Appliance in the Rack
Caution
Lifting the appliance and attaching it to the rack is a two-person job. If needed, use an appropriate lifting
device. A fully loaded Cisco ADE 2130 and 2140 Series appliance weighs approximately 51.5 lb
(23.4 kg).
device. A fully loaded Cisco ADE 2130 and 2140 Series appliance weighs approximately 51.5 lb
(23.4 kg).
Before you begin, check the 10-32 x 1/2-inch screws that are included in the 2-post rack-mount kit (see
) to see if they are the correct size for your rack. If not, obtain the correct screws
to use in the procedure where “rack screws” are required.
To mount the appliance in the rack:
Step 1
Locate one person at the front of the rack and one at the rear.
Step 2
Position an L bracket on the front side of the center post (see
).
Figure 3-3
Attaching an L Bracket to a Center Post
Step 3
). Do not
fully tighten the screws at this time.
Step 4
Repeat Steps
for the other L bracket.
Step 5
Tighten all the 10-32 x 1.2-inch rack screws on both sides of the rack.
231949
Cisco R
TC Security Appliance